Product features
1. Has high bond strength. Support heavy tiles and stone, reducing slippage problems.
2. Be premixed and produced. Ready to use latex adhesive designed for interior installations of ceramic tile and natural stone on both floors and walls.
3. Has strong water retention, no need to dip tiles and wet walls, thin construction, easy operation, to reduce material consumption and building load.
4. Has good flexibility to withstand shock and vibration.
5. Has special formula to avoid completely the common phenomenon of tiles cracking, detaching and peeling by Portland cement.
6. It is non-toxic, non-flammable, non-radiation, non smell and environmental.
7. Has special formula to prevent the flow with too much southbound crash, easier construction.
Scope of application
|
YY-116 toughness
|
60cmX60cm tile or above
Tick up tile on old tile
Tick up tile on gypsum board, eterpan, plywood
|
Treatment of base plane
1. Base plane should be smooth and firm, no dust, grease, release agents, batik material, etc.
2. Check base plane roughness by 2m ruler, error should be less than 5mm.
3. New plastering cement mortar should be constructed after 14 days maintenances.
Construction technology
▲Construction tools: leveling instrument, dentiform drawknife (3 x 3mm, 4 x4mm, 6×6mm, 8×8mm, 10 x10mm), tile generator, motor stirrer, big drum, cross-colloidal.
▲Stir and mix: mix tile adhesive and water as 25: (6-6.5), stirs completely and waiting for 5 minutes and stir again.
▲Lay-up construction: scrape the glue paste evenly on base plane with dentiform drawknife, the area should be about 1 m ² each time, then knead and press on the base plane. The model of the dentiform drawknife depends on the size of the tiles.
Attentions
1. The vertical and smoothness of the substrate must be confirmed before construction.
2. The product is suitable for construction in the 5-40℃.
3. Don’t use the dried paste by re-adding water.
4. If the base plane is uneven or the back of tile is not smooth, wiping the paste on the back of brick in order to ensure it full with paste to avoid hollowing.
|
Use level list
|
||
|
Tile size
|
Drawknife size
|
Use level(kg/sqm)
|
|
10x10cm tile or mosaic or below
|
6x6mm tooth form for base
|
3-4
|
|
60x60cm tile and stone or below
|
8x8mm tooth form for base
|
4.5-6
|
|
60x60cm tile and stone or above
|
10x10mm tooth form for base
|
6-8
|
|
60x60cm tile and stone or below, with deep groove
|
8x8mm tooth form for base
3x3mm tooth form for tile back
|
6-8
|
|
60x60cm tile and stone or above, with deep groove
|
10x10mm tooth form for base
3x3mm tooth form for tile back
|
8-12
|
Storage period
Keep in a cool and dry place, unopened powder valid for one year.
Spec: 25kg/bag