Automotive Spray Paint

Description:

1.100% acrylic resin 

2. Fast dry 

3. Be used in surface finishing and mending

Product introduction: 
 

This product is at room temperature silicone aerosol from the dry paint. It is made up of flexible operations, spray atomization, spray rate characteristics. Paint dry after 30 minutes at room temperature, table 200 degrees drying for 2 hours after the performance to achieve optimal. Long-term heat below 300 degrees and maintain good performance, silver temperature up to 400 ° C 

Usage area: 
 

Mainly applies to the chimney, pipes, car engines, car exhaust pipe, motorcycle engines, motorcycle exhaust pipes, and other high-temperature environments. 

How to use: 

1. Completely remove the need to paint parts of the oil, water and dust. 

2. Paint up and down, shaking the jar for about 2 minutes to spray mixed thoroughly. 

3. Away from being sprayed surface of about 20-30 cm, uniform spray pressure nozzle back and forth with the index finger, the proposed construction to the number of times: Three times, each construction interval 5-10 minutes is the best. 

Note: 
 

1. Keep out of the reach of children. 

2. The jet aerosol cans upright and the horizontal angle of not less than 45 ° Must be maintained. 

3. The construction at the air circulation. 

4. If splashed into the eyes should immediately wash with water, and then seek medical attention. 

5. If not accidentally swallowed induce vomiting immediately and seek medical attention. 

6. This product is flammable, stored below 40 ° C, do not on the car, away from heat and open flame is strictly prohibited exposure, punctured. 

7. Net and gross over time and change is a normal phenomenon of aerosol products. The loss rate of less than or equal to 2% / year. 

Treatment of the waste: 
 

1. The inverted jar with old newspapers or waste tank pressure vents about 2 minutes to remove the remaining material. 

2. Where necessary, you can unplug to cover to clean it.