Floating pipelines are a very cost-effective solution. Worn-out pipe pieces can easily be exchanged by pulling the rubber floater over a new pipe piece. The steel pipe however makes this floating line less flexible and reduces the applicability at rough seas. Therefore these pipes must be used in combination with floating hoses. Floating hoses are a more flexible but still very robust solution for discharging slurry to the shore. For extra wear resistance the floating hose is also available as BoneCrusher? type with wear resistant steel rings integrated in the rubber.

Discharge Rubber Hose
Main Material: Natural Rubber
Inside Diameter		Working Presure		Burst Presure		Vacuum Presure		Adhesive Strength	Abrasion value	Length	Bending angle
mm	inch	Mpa	bar	Mpa	bar	Kpa	bar	KN/m	cm3	m	°
254	10"	1.5	15	4.5	45	80	0.8	≥4	≤0.4	6-15	0°-  45°
304	12"	1.5	15	4.5	45	80	0.8	≥4	≤0.4	6-15	0°-  45°
350	14"	1.5	15	4.5	45	80	0.8	≥4	≤0.4	6-15	0°-  45°
400	16"	1.5	15	4.5	45	80	0.8	≥4	≤0.4	6-15	0°-  45°
450	18"	1.5	15	4.5	45	80	0.8	≥4	≤0.4	6-15	0°-  45°
500	20"	1.5	15	4.5	45	80	0.8	≥4	≤0.4	6-15	0°-  45°
550	22"	1.5	15	4.5	45	80	0.8	≥4	≤0.4	6-15	0°-  45°
600	24"	2	20	6	60	80	0.8	≥4	≤0.4	6-15	0°-  45°
800	32"	2	20	6	60	80	0.8	≥4	≤0.4	6-15	0°-  45°
850	34"	2	20	6	60	80	0.8	≥4	≤0.4	6-15	0°-  45°
900	36"	2	20	6	60	80	0.8	≥4	≤0.4	6-15	0°-  45°
1000	40"	2	20	6	60	80	0.8	≥4	≤0.4	6-15	0°-  45°
1200	48"	2	20	6	60	80	0.8	≥4	≤0.4	6-15	0°-  45°
1300	52"	2	20	6	60	80	0.8	≥4	≤0.4	6-15	0°-  45°
NOTE: The parameter above are all for normal conditions, our factory can make all kinds of rubber hose products by your requirements.