| Place of Origin: | China (Mainland) |
|---|---|
| Brand Name: | Shiny Mould |
| Model Number: | No. 13125 |
Quick Details
Specifications
Detailed Product Description
Pipe Fitting Plastic Injection Mould PP , DME Base Cold Runner
| Part Name: | Pipe Fitting | Plastic Material: | PP |
| Cavity Material: | H13 HRC48-52 | Gate Type: | Direct Gate |
| Mold Base Standard: | LKM Local Standard | Mold Type: | Plastic Injection Mould |
| Runner: | Cold Runner | Locating Ring Dimension: | Ф100 |
Quick Detail:
1. The part name: pipe fitting (plastic injection mold)
2. Plastic material: PP
3. Cavity material: H13 HRC48-52
4. Mold life: 1000k shots or according to customers quantity condition to decide it with saving cost for our customers.
5. Gate type: sub-gate, fan gate, point gate, edge gate, valve gate, tip gate etc according to our customers requires.
6. Mold base standard: LKM Local standard, DME or HASCO,Customize according to customers' requirements
7. Standard of mold accessories: LKM, DME, HASCO, MISUMI, Meusburger, CUMSA, Progressive, INCORE, HRS, Husky, YUDO, PETS, MOLD-MASTER, MERKLE, Parker, HPS, LKM, EUCHNER, RJG, cilpres, NITTO, CRACK, ASSAB, GSW DIN standard, BOHLER, AISI standard, DAIDO JIS standard, PUNCH etc according to our customers requires.
Description:
The part name: pipe fitting
Mold type: Plastic Injection Mould with cold runner system
Part Material: PP
Locating ring Dimension: Ф100
KO Pattern: 200*200
Sprue Radius: SR 19
Ejection type: lifter ejection
Mold construction description: Hot runner system, 3 inner sliders and 2 outer large sliders, 3 lifters and 2 plates, many shut off area in the mold, Explosion core.
This product is made of PP plastic material and it is one of the components of the reputable brand pipe fitting. The construction is complicated and there are 6 small sliders in the cavity, 6 lifters and 2 big sliders in core side in the mold, so it has a very high technical requirement for the mould design. The mould is a cold runner mould with water cooling system and the part can be molded by both automatically and manually.
This part has high appearance and size requirements, the defect showed below will not be acceptable, for example, weld line, Dark Sport,Sliver Marks,Gas Trap Effect,Visible Ejector Marks,Deformation,Short shot Filling,Burnt Streaks,Sink Marks,Flash,Over dimension,Under dimension,Stress Crack etc. Moreover, the product finishing surface must meet the requires more than SPI-SPE-B2.