Description:

 The part name: pipe fitting

Mold type: Plastic Injection Mould

Part Material: PP

Locating ring Dimension: Ф100

KO Pattern: 200*200

Sprue Radius: SR 19

Gates/Runners: Cold Runner, Hot Runner, Shut off

Mold construction description: Hot runner system, slider, lifter, 2 plate, and 3plate

Ejection type: Pins, Sleeves, Air valve, Stripper Bar, cavity ejection, Stripper Plate, Auto unscrew, Stripper Ring

 

This product is made of PP plastic material and it is one of the components of the reputable brand pipe fitting. The construction is complicated and there are hydraulic cylinder, hydraulic motors, gear, fan gear, gear-rack in the mold, so it has a very high technical requirement for the mould design. The mould is a cold runner mould with water cooling system and the part can be molded by both automatically and manually.

 

This part has very high appearance and size requirements, the defect showed below will not be acceptable, for example, weld line, Dark Sport,Sliver Marks,Gas Trap Effect,Visible Ejector Marks,Deformation,Short shot Filling,Burnt Streaks,Sink Marks,Flash,Over dimension,Under dimension,Stress Crack etc. Moreover, the product finishing surface must meet the requires more than SPI-SPE-B1.

 

This mould is made in Shiny Mould Factory. It is a mould exported to Europe, with complicated structures and high quality requests. Customer needs mold life to be over 1 million shots. We can ensure this mold life and give warrant to our customer that once some mould components are broken during working, if it is caused not by the operation fault from the workers, we can provide new mould components to them free of charge.