?Brief Introduction

LS Series High Efficient Horizontal Flexible Screw Flight  is a general-purpose continuous-conveying equipment which transports bulk materials from one place to another. It is designed to transfer powdery or granular materials in both horizontally and on a slight tilt. The temperature of the material must lower than 200°C, and the installation angle of conveyor may reach 20°. 

 

?Working Principle

The materials are feeded into the casing and screw flight was hold back by the frication resistance acted on the wall of casing during running, the screw flight push the materials and make the materials do axial movement, the materials can be discharged at the proper outlet at the bottom of casing or transport out at the end of chute.

?Features 

1. Flexible screw conveyor

2. Convenient to load and unload

3. Good sealing performance

4. Multiple inlets and outlets

5. Simple operation and convenient maintenance

6. Totally-enclosed structure, small cross section size, low cost

 

?Application   

LS Series High Efficient Horizontal Flexible Screw Flight is a material handling equipment that uses for transportation of concrete, flour, grains, chemical, fertilizer, ash, sand, gravel, coal, small lump coal and other materials. About the block material, the conveyor is not easy to transport perishable, viscous large, easy caking materials. 

 

?Technical Parameters

Model No.	Diameter of Screw   (mm)	Distance between Screws (mm)	Rotary Speed (r/min)	Conveying Capacity(m3/h)	Power     (kW)
LS-100	100	100	140	2.2	1.6
LS-160	160	160	120	7.6	2.8
LS-200	200	200	90	11	3.2
LS-250	250	250	90	22	5.3
LS-315	315	315	75	36.4	8.4
LS-400	400	355	75	66.1	11
LS-500	500	400	60	93.1	15.3
LS-630	630	450	60	160	25.9
LS-800	800	500	45	223	36
LS-1000	1000	560	35	304	48
LS-1250	1250	630	30	458	73.3

 

?Selection Guidelines

1. The conveying material

2. The physical characteristics of material, such as bulk density, feeding size, temperature, mositure content, etc.

3. The processing capacity of the conveyor

4. The conveying length (distance between inlet and outlet)

5. The inclination angle of the conveyor