| Place of Origin: | China (Mainland) |
|---|---|
| Brand Name: | giga |
| Model Number: | giga0015 |
| size: | 915*1830mm 1220*2440mm |
| color: | black brown red |
Quick Details
Specifications
GIGA construct plywood is suitable for outside high-end and highbuilding construction and bridge construction.It's large breadth make it able to reduce the quantity of seam and improve the working efficiency of membrane. Good water resistance,strength properties, high turnover times, long service life, easy mold release by only taking the time 1/7 of the steel mould.
GIGA film faced Plywood other information:
1.Colour - Brown/Black
2.Face Veneer: Poplar
3.Core Veneer:
100 High Density, Eco Friendly - Rubber Wood
4.Glue:
WBP Glue - Phenol glue (100 hours boiling water tested)Or
MR Glue - Melamine glue (cold water resistant)
5.Size & Thickness
Thickness:18mm-12mm
Sizes:1830mmx915mm, 2440mmx1220mm or as required
GIGA plywood advantages
1. High bending strength.
2. Strong nail holding.
3. Moisture-proof and easy work.
4. Tight construction and high strength.
5. No ratten or decay.
6. Low formaldehyde emission.
7.made of waterproof melamine/WBP glue(high viscosity pure phenol glue)
8. The productions are suitable for the construction of viaduct and tall frame building.
9. If put in boilding water for 24 hours, it still glue sticking and still formed.
10. Fine waterproof performance, the adhesive will not unglued within boiling water, no deformation when be affected by water and damp
11.higher cost performance
12.professional plywood manufacturer for 16 year
13.more safe and effective in building project
warm tips
1.Plywood should be set in a dry place over leveled crossbars.
2.Keep the panels stay dry, If panels are wet, do not allow them to dry too rapidly.
3.Don't put them in rain or wet place
4. Plywood should be carefully handled so that the faces and edges are not damaged.
5.After cutting and/or drilling, the fresh surfaces should be sealed with water-resistant paint. 6. Always clean and repair the formwork panels before storage. The formwork should then be stacked off the ground on level supports and under cover.
7.Framed formwork panels should be stacked alternately back to back to avoid face damages by bolts etc.
8.It may be necessary to use a hard wood scraper but care should be taken not to damage the plywood face. Do not use a wire brush or sharp
8.It may be necessary to use a hard wood scraper but care should be taken not to damage the plywood face. Do not use a wire brush or sharp