JMY506 series are RFID reader/writer module with UART and IIC serial ports. JMY506 has various functions and supports multi ISO/IEC standard of contactless card; the cards from different suppliers. The RF protocol is complex. But the designer combined some frequent used command of RF card and then user could operate the cards with full function by sending simple command to the module through IIC or UART interface. And the module and antenna are separate design. The impedance between RF module and antenna was tuned by impedance analyzer. And then the module has excellent performance and stability. The module and antenna is linked by 50ohm coaxial line. The performance is good, though the wire can reach 10m. Normally the wire should be 60cm that is the module's best performance and stability.

Qualifications:

• RF standard: ISO14443A, ISO14443B
• Operating distance: 80mm(depending on card and antenna design)
• Anti collision ability: Full function anti collision; be able to process multi-cards simultaneously; be able to set operate single card only
• Auto detecting card: Supported, default OFF
• EEPROM: 512 Bytes
• Interface: IIC&UART(selected by SPS pin, recommend to use IIC)
• Communication rate: IIC--400Kbps, UART--19.2Kbps/115.2Kbps
• Max.command length: 254 Bytes
• Interface level: 3.3V(TTL level; 5V tolerance)
• Power supply: DC 5.0V
• Power consumption: 50mA
• Dimension: 42mm×21mm×8mm
• Package: DIP32
• Weight: about 15g
• Operating temperature: -25 ~ +85 ℃ (-77 ~ +185°F)
• Storage temperature: -40 ~ +125 ℃ (-104 ~ +257°F)
• ISP: Supported
• RoHS: Compliant