1. The mill is used for rubber plasticating, mix, warming and sheeting.
2. The mill consists mainly for rolls, frame, bearing, roll nip adjusting, screws, heating and cooling device, emergency stop, lubrication system and such sections as electrical controls and, etc. The main electric motor arrives the front and rear rolls to rotate oppositely through hardened reducer, driving gears and friction gears.
3. The rolls are made of chilled alloyed castiron. Their working surfaces are of high hardness and wear-resistant. The working temperature of the bored roll is controllable by steam, cooling water or oil that pass through them thus, to meet the requirements of milling process.
4. Roll nip adjustment is realized by hand or electro-motion operation which can obtain high accuracy and sensitivity
5. The mill performs well in energy saving, environmental protection and easy installation and operation, meanwhile, it has a longer service life.
6. It is set up the overload protecting and emergency stop device to ensure safety of body and equipment.