Use and repair
1, the machine should be installed in the electrical protection device.
In early 2, the machine running the anchor bolts, check at least once a day, to prevent loosening.
3, when the motor rotation direction does not meet the requirements, adjust the power phase sequence.
4, the machine stops again after a longer period of time when using, should measure the insulation resistance, for 500 volt megger, should be greater than 500000000000 in europe.
5, the machine is running a total of 1500 hours, you should check the bearings, if serious injury should be replaced immediately.
6, the motor should be to ensure good lubrication, each running two weeks supplementation of lithium based grease (ZL-3) once, petrol, oil cup to add the amount of lithium base grease. When using sealed bearings, motor without installation.