APPLICATION

This series of water meter is used to measure the total quantity of cold potable water which consumed in household or a resident unit, passing through the pipeline. 

FEATURES & BENEFITS

 Single-jet velocity meter, magnetic drive, lower transmission resistance.

 Suitable for horizontal installation R80/100 or vertical installation R25.

 The body can be plastic painted or chrome coated, or nickel coated for optional.

 Dry-dial type, small body, inlet strainer,light weight, 8 digits and 1 red point, magnet resistance.

 Sealed dry dial register ensures frost resistance and keep clear reading for long time.

 Register can rotate free 360 degrees for easily reading in any position.

  External regulating device and remote transmission device for optional.

 Approvals in over 50 countries.

CONSTRUCTION

The meter mainly consists of a body, a impeller, a indicator unit, a seal plate, a impact plate, a plastic ring with lid. The impact plate secures the internal parts.

WORKING PRINCIPLE

The water operates on the velocity principle that a jet of water enters the water meter body and drives the impeller. The impeller is suspended by hydrodynamic forces to give minimum load on the bearings. The impeller rotation is magnetically transmitted to the register which the reading is made.

COMPLIANCE WITH STANDARD

Technical data conforms to ISO 4064:2005 Standard for horizontal installation/vertical installation.

Threaded connections comply with BSP Standard.

WORKING CONDITIONS

Working temperature Class: T30 or T50 for cold water meter

                                         T90 for hot water meter

Working Pressure Class: MAP10 or MAP16

Pressure Loss Class:    P63

Upstream Disturbance Class: U5

Downstream Disturbance Class: U0

ACCESSORIES

Every water meter will complete with 2 couplings, 2 nuts, 2 coupling gaskets and 2 spud thread protectors.

MAXIMUM PERMISSIBLE ERROR

In the lower zone from Q1 inclusive up to but excluding Q2 is: Cold potable and hot water meter ± 5%

In the upper zone from Q2 inclusive up to and including Q4 is: Cold potable water meter ± 2%, hot water meter ± 3%

INSTALLATION  REQUIREMENTS:

Step-1:The meter should be installed in HORIZONTAL position with the direction of the flow as indicated by the arrow cast in the meter body with the register face upwards.

Step-2: Pipeline must be flushed before installation.

Step-3:The meter should be constantly full of water during operation.