features:

1.Please install the roller lock sets symmetrically
when mold closing, at least 2 sets roller lock sets
for 1 mold (user can select the quantity according to
the actual conditions , available in 3 sizes)

2.The " H" in figure1 is the first stroke of mold opening; adjust the
position of control bracket and the plates, Mount control bracket
with spacer with screw and dowel pins. Match the catch housing
and latch bar, then slide them in to the control bracket, mount the
catch housing into A mold plate and fix the latch bar on B mold
plate with screw and dowel pin.

3.The mounting faces for control bracket, catch housing and latch
bar must be machined parallel to the mould guiding system.

4.In such a way as to prevent tilting of the plate to be drawn.

5.After finished the H1 stroke, the catches of the catch housing
stay in the recess of the control bracket, and the catches would
be locked so that the latch bar can remove from the control
bracket smoothly; but if the H1 stroke is improperly set, and the
stroke is finished, so that the catches can not reach the recess
of control bracket, when force to open the mold , will cause the
latch lock unit be damaged .

6.This latch lock is the precise standardized item, please do not
apply together with other own customer machined parts, we will
not be responsible for any anomaly caused by it.

7.It should be installed in the precise mould base.

8.If need to maintain, please remove the latch locks first.

9.After installed, Carry out a functional test, check whether the
Individual parts of the latch lock units moves smoothly or the
stroke is applicable.