Product specifications
|
Model
|
YT-W300T
|
YT-W300R
|
|
Supported Resolution
|
1080p 1080i 720p
|
|
HDMI Interface
|
Support HDMI1.4A video/audio format and encrypted video format HDCP2.0
|
|
Transmission Distance
|
35m without obstacles
|
|
System Latency
|
<1 ms
|
|
Antenna
|
Omni bearing built-in antenna
|
|
Power
|
100~ 240V alternating input current, 5V 3A direct current output power adaptor
|
|
Certificates
|
FCC CE
|
|
standard
|
WHDI 1.0
|
|
Supported interface
|
3.5mm plug,built out infrared remote control connector
|
Built in infrared receiving area
|
|
Working temperature
|
0℃ - 50℃
|
|
Dimension
|
146(L)*93(W)*25(H)mm
|
Product Feature
- Working frequency: 4.9Hz~ 5.9 GHz
- YTS function
- Compatible design
- Built-in antenna
- With a transmission distance of 35m without latency
- Remote control
- Support 3D effect
Troubleshooting
Please make sure all the devices is properly connected and receiver is not in standby mode before you follow the troubleshooting guide below.
|
No video
|
1, Check the status of LED, and check if the HD media player works normally.
2. Check if the joints and wires are damaged and make sure they are correctly connected to corresponding interface.
2, 3. Ensure there is video on output devices.
3, 4. Check the receiver is correctly connected to display equipment.
4, 5. Make sure all devices are working on supported distance. Draw them closer and try it again.
|
|
Power LED off
|
1, Make sure the power adaptor is correctly connected and the voltage is 5V3A
2, Make sure the power supply would not be interrupted.
3, Make sure transmitter is fully powered.
|
|
Receiver video indicating LED abnormal
|
1, Make sure video and audio signals can be transmitted to receiver successfully.
2, If there are video and audio signal on output devices, please check the indicating LED to see if something got wrong with it.
3, Make sure the device is working within the supported distance.
|
|
Bad picture
|
1. Ensure there is video on output devices.
2. Check if the receiver is correctly connected to display equipment and there is no damage on joints and wires.
3. Make sure all devices are working on supported distance. Draw them closer and try it again.
|
|
No sound or bad sound
|
1. Restart the transmitter and connect it again
2. Make sure there is no disturbance from the same frequency (4.9～5.9GHz)within 1 meter.
|
|
Register failure
|
1. Make sure the amount of registered source devices on display equipment is less than 8.
2. Ensure the distance between transmitter and receiver doesn't exceed supported distance. If it does, make them closer and try it again.
Check if source device has been added on display equipment. If it has, delete it and make registration again.
|
|
Connection failure
|
1. Ensure the working distance doesn't exceed supported distance. If it does, make them closer and try it again.
2. Make sure source devices have been registered every time after software update.
3. Ensure source devices and display devices have been registered.
4. If failure occurs again, delete all registered information and try it again.
|
|
Other problems
|
If any other problems occur, please restart the device and make connections again.
|
