| Place of Origin: | China (Mainland) |
|---|---|
| Brand Name: | wantai |
| Model Number: | |
| Certification: | |
| Type: | stepper motor |
| Protect Feature: | |
| Output Power: | |
| Voltage(V): | |
| Efficiency: |
Quick Details
Specifications
This Item includes:
3PC Nema 34 Stepper motor 85BYGH450D-008 5.6A 1087oz-in 2.13V
3PC Stepping Motor Driver DQ860MA with 7.8A 24-80v
3PC POWER SUPPLY with 350W, 60V
1 PC Breakout Board & 1 Cable
Technical Specifications
Part No.: 34HS9456 (85BYGH450D-008) Single Shaft
Frame Size: NEMA34
Step Angle: 1.8 degree
Voltage: 2.13V
Current: 5.6A/phase
Resistance: 0.38Ohm/phase
Inductance: 4.1 mH/phase
Holding torque: 7.7N.m 1087oz-in
Rotor inertia: 1700g-cm2
Number of wire leads: 4
Weight: 3kg
Length: 99mm
2 Stepper motor driver: DQ860MA
Introduction:
DQ860MA is a type of two-phase hybrid stepping motor driver, the drive voltage of it is from 24VDC to
80VDC. It is designed for use with 2-phase hybrid stepper motor of all kinds with 57mm to 110mm outside
diameter and less than 7.8A phase current. This circuit that it adopts is similar to the circuit of servo control
which enables the motor run smoothly almost without noise and vibration. Holding torque when DQ860MA
runs under high speed, is also significantly higher than the other two-phase driver, what's more, the positioning
accuracy is also higher. It is widely used in middle and big size numerical control devices such as curving
machine, CNC machine, and computer embroider machine, packing machines and so on.
Features:
l High performance, low price
l Average current control, 2-phase sinusoidal output current drive
l Supply voltage from 24VDC to 80VDC
l Opto-isolated signal I/O
l Overvoltage, under voltage, overcurrent, phase short circuit protection
l 14 channels subdivision and automatic idle-current reduction
l 8 channels output phase current setting
l Offline command input terminal
l Motor torque is related to speed, but not related to step/revolution
l High start speed
l High holding torque under high speed
Electrical specification:
Input voltage
24-80VDC
Input current
＜ 6A
Output current
2.8A～7.8A
Consumption
Consumption: 80W; Internal Insurance: 10A
Temperature
Working Temperature -10～45℃;
Stocking temperature -40℃～70℃
Humidity
No condensation, no water droplets
gas
Prohibition of combustible gases and conductive dust
weight
500G
Pins assignments and description:
1) Connector Pins Configurations
Pin Function
Details
PUL +,PUL-
Pulse signal, PUL+ is the positive end of pulses input pin
PUL- is the negative end of pulse input pin
DIR+,DIR-
DIR signal: DIR+ is the positive end of direction input pin
DIR- is the negative end of direction input pin
ENBL+
Enable signal: ENBL+ is the positive end of direction input pin. This signal is used for enabling/disabling the driver. High level for enabling the driver and low level for disabling the driver.
ENBL-
ENBL- is the negative end of direction input pin. Usually left unconnected (enabled)
3 power supply:350W, 60V
4 breakout board: DB25