2400mm Single Mould Cylinder Single Dryer Toilet paper machine

1 Overview

This machine is apply to produce 13-25g/m2 base paper of toilet paper and facial tissue,which can be processed into toilet paper, napkin paper, facial tissue, pocket tissue, wet strength paper etc finished products. The machine can be divided into left hand machine and right hand machine according to drive position.

2 Technology Condition

2.1 Pulp: wood pulp, waste paper pulp etc

2.2 Stock concentration: 0.1-0.6%

2.3 Beating degree: 26～38°SR

2.4 Dryness of each part: out of the cylinder mould: 18-20%

before dryer 36-40%

Out of the dryer: 91-94%

Finished paper: 91-94%

2.5 Average Shrinkage: 3～5％

2.6 Daily working hours: 22.5 hours

2.7 Manufacture paper rate:96%

2.8 Rate of finished product:95%

2.9 lineal pressure of touch roll:100kn/m

3 Basic Energy Conditions

3.1 Alternating voltage: 380v, 50Hz

3.2 Control voltage: 220/24v

3.3 Water pressure: 0.3MPa, working pressure: 0.2MPa

3.4 Compressed Air Pressure: 0.6MPa, working speed: 0.4MPa

3.5 Steam pressure: 1MPa, working pressure: 0.5MPa

3.6 Vacuum degree of suction box: 0.024～0.04MPa

3.7 Sucking rate: 24m3/min

3.8 Water requirement: no color, inclusion-free, PH=6.8

4 Paper machine basis data

4.1 Main product: base paper of toilet paper, napkin paper, facial tissue etc

4.2 Trimmed width: 2400mm

4.3 Basis weight: 13-25g/m2

4.4 Drive speed: 280m/min

4.5 Working speed: 250m/min

4.6 Nominal capacity: 8t/d

4.7 Gauge: 3400mm

4.8 Reeling-up way: under the reel drum

4.9 Drive type: AC motor Frequency Variable Driving, cylinder mould, dryer

and reel drum sectional drive, unified control. Signal by fiber

              transmission.

4.10 Layout type: single wire

4.11 Dimension: 14.5m×7m×6.5m(l*w*h)