Features:

1. PCB materials:

Aluminum PCB,the thermal conductivity is more than 200.

2. Lampshade

1)Material:PC

2)Color:transparent/milky PC optional

3)Light transmission rate:transparent(95%),milky(85%)

4)The emitting effect well-distributed

3.LED light source

1)Adopts high brightness TAIWAN Epistar SMD2835 LED chip

2)CRI can reach over 80Ra.

3)CCT:W2700-3000K,WW3000-3500K,NW4000-4500K,CW5000-5500K,DW6000-6500K

4.Power supply

High efficient,high PF 0.95,low temperature,strong safety,quality assurance

5.Standard size 2ft,3ft,4ft and 5ft optional,can customize measurement as your request

6.Energy-saving

Saving more than 70% compared with flurescent lamp

How to Install JDY LED tube?
1. Cut off the power before installation;
2. No starter, NO ballast, or electronic switch is required;
3. Install lamp stand and T8 tube holder first with the same length;
4. Lamp working voltage is AC85-265V.
5. Connect the two wire terminals located at the side of the tube to the electricity L and N respectively;
6. Do not supply the power to both pins on the same end simultaneously

Applications

1. Bus, shuttle, railcar passenger interiors;

2. Uninterrupted emergency lighting;

3. Focused reading and Task lighting;

4. Interior design uses;

5. Closet illumination;

6. Cove lighting;

7. Marine recreation applications;

8. Concealed accent lighting;

9. Edge lighting;

10. Counter lighting;

11. Cubicle, workbench lighting;

12. Recreational vehicle interiors.

Matters need attention:

1.Open the package, check whether the products are in good condition; If products are damaged , please kindly keep the package and send details to our company timely; please don't try to use the damaged products.

2. Voltage is AC95-265V, 50-60Hz,It will affect function and lifespan on the condition that voltage is too high or too low.

3. Do not install lamps inside combustible object. Any condition, lamps should not be covered by insulation blanket or similar material and so on.

4. When install and replace tubes, must switch off power and insure all adapter connectors connected correctly to make sure safety.

5. LED tubes without any dimming sticker; they can't be used in dimmer place.

6. The applying locations of LED tube are indoor and waterproof place, they are IP20 and not used in outdoor and in the rain.

7. When tubes work abnormally (extinguish, flashing), please check up the contacted properties of tube holder and lamp socket. And check if the power supply voltage is normal or not. If everything is normal, so you need to replace new tubes.

8. Follow the user manual when you install LED tubes strictly. It is prohibited to use LED tubes before adjusting old fixtures.

9. This product is installed by professional person; laypeople shall not dismantle or install it.