3mm abs filament for 3d printer

PLA Filament and ABS Filament is commonly used in 3D printing, has the following characteristics:

(1) High strength, good toughness;
(2) Density is small, when printing larger volume model lighter, save money;
(3) Cost-effective, can be processed in wide range temperature;
(4) ABS softer than PLA;
(5) Diameter of 3.0/1.75mm, variations + /-0.1mm,roundness +/-0.05mm;
(6) 1 kg /plastic spool packaging, can be automatic feed;
(7) To be applied to a variety of 3D printer, Makerbot, UP plus, Mendel, Prusa, series, etc.

(8) No  Bubble

Production Control 
1.Produce process 
I . Before produce extruding filament ,we will dry ABS and PLA for a enough time (3-5 hours). 
II. Mix with colors masterbatch or colors powder, all which .certified with ROHS. 
III.Adjust temperature and dragging rate , make filament diameter range at 1.6-1.8mm/2.8-3.0mm, roundness +/-0.05mm, each spool net weight 1kg+/-0.02kg.
IV we put all filament spool in shelf, different kind in different shelf, all categories arranged orderly. 
2.About waste & recycle 
Much time you will find some black filament is too brittle, that added and mixed with some recycle and scrap after produced. 
We haven't produced with scrap outlet, rework&recycle material, or dispose, but for quality assurance purpose. 
3.packaging 
We put each filament /spool on seal PE bag with desiccant , then smaller carton, then out big box 
We also have vacuum heated bag to replace of PE bag, make better avoid moisture.

4.Productiong quality control

I. we have diameter laser detect kits to control extruding rate on line, when diameter smaller or higher than accept range, the laser detect kits will adjust the extruding rate higher or smaller to make diameter range at acceptable.

II.keep each record filament samples sent to customers, build a tracking able document.

III.when the filament put on shelf longer than half a year, we will dry the filament again.