~Overview and Uses

The medium frequency induction furnace apply to iron and steel, copper, Ceruse, aluminum, zinc, nickel, gold and silver and other metal melting, heating, insulation, and forging, sintering, hot rolling, bending forming pre-heat treatment. Is mainly used in melting foundry industry.

Equipment Main Features

1, Using a zero-voltage scanning soft-start mode, in any case may at any time to start or stop, will not have impact on power supply.

2, Rapid melting, the production cost is low; Pollution is small, comply with environmental requirements;

3, A direct effect from the cold furnace melting. Dissolved material will be fully dumped clean. Molten material easy to replace.

4, Power adjustment flexibility. Be able to continuously smooth adjustment. Temperature uniformity can be easily controlled. Oxidation burning less. Metal components evenly.

5, Furnace shell using cast aluminum or steel structure, small footprint; Furnace flip dump convenience, according to the need to use electric, manual, hydraulic tilting furnace and other means.

6, Designed to automatically adjust angle of inverter circuit that can automatically adjust the load impedance match, without adjustment of capacitance compensation and always run the equipment in good working condition; Power supply system diagnostic error function, easy maintenance.

MF Melting furnace Range of molten iron capacity Ton 0.2
Max working temperature C 1650
Melting rate ton/h 0.2
Cooling water R ate of flow ton/h 15
Pressure Mpa 0.2
water inflow temperature C > 40
Temperature rise C > 20
Induction heater voltage V 1500
Induction inner diameter mm 420
Induction heater total height mm 600
Turndown method mechanical drive
MF Induction heating machine Range of power kw 200
Incoming line voltage V 380
Max incoming line current A 320
rectifier pulse number pulse 6
cooling water rate of flow ton/h 50
pressure Mpa 0.1
water inflow temperature C > 35
Temperature rise C >15
MF voltage V 750
MF frequency HZ 1000