Bearing Insert in Stainless Steel SUC

Wide Inner Race, Set Screw Locking, Normal Duty
Wide inner ring with spherical outer ring
Lubrication groove with oil hole on set screw side
Anti-rotation pin on side opposite grease groove
Supplied with water/wash resistant Mobil grease FM222 (FDA/USDA approved)
Standard seal: FDA approved silicone rubber seal protected by stainless steel slinger
Operating Temperature Range -35C to +120C
Shaft diameter from 12mm to 90mm

Stainless Steel Bearing Insert Material.

1. Inner and Outer Ring: AISI 440C
2. Balls: AISI 440C or 100Cr6
3. Retainer: AISI 304
4. Set screw: AISI 304
5. Seal: Nitril rubber(NBR) or FDA approved silicone(Si) rubber
6. Slinger: AISI 304

Seals used on Stainless Steel bearings.

NHK Stainless steel bearings incorporate silicone rubber seals in compliance with FDA guidelines.
Stainless steel slingers are also available on wide inner ring stainless steel bearings.

Seal Materials Comparison:
BASE POLYMER: NITRILE(NBR) or SILICONE(Si)
Temperature Range NBR: -40F to 250F (-35C to 120C)
Temperature Range Si: -80F to 400F (-60C to 200C)

Set Screw Locking Mechanisms

This incorporates two AISI 304 set screws spaced 62 degrees apart in the inner ring extension.
The areas around the set screws are high frequency annealed to allow the use of larger diameter set screws further increasing their effectiveness.
The addition of a nylon patch to the set screws prevents their backing out under high vibration situations.