TDS-98302 DIST 2 TDS meter TDS tester family

Specification:

Range:0-10ppt         Resolution:0.01ppt

Accuracy: 2% F.S.      Power:4*1.5V

Calibration: 1 point  Dimension:175*41*23mm  ATC: 0-50℃

N.W:90g    G.W: 130g

Package: 100pcs/carton, 14kg/carton

OPERATION

? Remove the protective cap. Don't be worry if white crystals appear around the probe head. This is normal with electrodes and they dissolve when rinsed with water.

? Turn the meter on by sliding switch on the top.

? Immerse into solution up to the max immersion level.

? Stir gently and wait until the display stabilizes.

? After use, switch off pH meter, use the water clean the electrode and replace the protective cap.

? Large fluctuations in readings could be due to lack of calibration, dry electrode or rundown batteries.

 

 

BATTERY REPLACEMENT

When the meter cannot be switched on or the display fades, pull out the battery compartment and replace all three 1.5V batteries, while paying attention to their polarity. Batteries should only be replaced in a safe area using the battery type specified in  instruction manual.(1.5 Alklaine or AG13)