KOTO brand(sequential number:BSMJk),SYNTEC Brand(sequential number:BSMJs) BSMJ series self-healing low-voltage shunt power capacitor suit for the power network of frequency 50Hz or 60Hz to compensate the reactive power,improve the power factor of network and the voltage quality,raise the device output power and reduce the loss of power and energy. Main features: 1.Use the imported material,with small size,lightweight,and easy installation and maintenance(the unloadable seat is the original in China).2.Adopts fantastic golden and silver metal printing(patent).3.With high reliability,the market quality satisfaction rate is 99.99%,with two years guarantee .4.High safety,with discharge resistance and over-pressure protective device inside.5.Low dielectric loss and perfect self-healing performance.6.Adopts nontoxic,environment friendly impregnated material made of solid capacitor wax. Main Technical Specification:1、Apply standard:GB12747-2003 IEC60831-1:19962、Apply condition:Indoor,-25°C~40°C,humidity:<=80%RH,height<=2000MSL3、Rated voltage:230VAC、250VAC、400VAC、415VAC、450VAC、525VAC、690VAC4、Rated output:1~60Kvar5、Capacitance tolence:0~10%6、Voltage endurance:2Un 10 seconds between T-T，3000VAC 10 seconds between T-C. 7、Insulating resistance：more than 1000MΩ between T-C at 500 VDC in one minute.8、Loss angle tangent:Less than 0.1%(rated voltage at 20°C).9、Ceiling voltage:1.1Un(root mean square value ) 10、Ceiling current:1.3In(root mean square value )11、Self-discharge feature:The terminal voltage will reduce below 50V in 3 minutes after disconnecting from power line.12、The capacitors temperature rise in normal operation is less than 8°C. Notes:1.Install it in the dry and well-ventilated place,prevent it from the corrosive gas or dust,from the direct sunlight and the rainy or snow.2.The installation gap of two capacitors should be more than 50mm to benefit for heat radiation.3.The connect wire should wear the capacitor over 1.3In and is reliable connection.4.To regulation the power factor,connect anti-rush reactor or capacity contactor to avoid of rush current damaging the capacitor.5.Using serial inductors when capacitors used in the environment that with high harmonic wave content.6.To avoid of the superposing voltage damaging the capacitor,capacitor must be discharged over 3 minutes before re-input.7.The capacitor should be used under rated voltage and current,or its life will be reduced if under an overrated condition. Contour drawing and size: Main Technical： Model Rated Voltage(V) Rated Reactive Power(KVAR) Total Capacitance(uF) Rated Current(A) Dimensions(mm) BSMJ 0.415-15-3 415 15 277 21.0 153*53*210