AMS 4928 titanium bar 
Round rod, rectangular, square and hexagonal bar 

Titanium rod and titanium bar are produced from bar billet by extruding, hot forging, rolling or swaging, depending on specific size, specification or customer's requirement. 

Available forms in Retimet include titanium round rod, rectangular bar, square bar and hexagonal bar. 

Quality assurance & Inspection 
* Chemical analysis 
* Mechanical properties 
* Dimensional tolerance 
* Surface contamination 
* Nondestructive examination (100% ultrasonic or X-ray) 
* Microstructure evaluation (alternative, upon requirement & specification) 

Size & Tolerance 
For titanium rod used in medical implants (ASTM F67 and F136), diameter ranges from 2 mm to bigger ones customer need. 
Depending on different requirements of OD tolerance, surface of titanium rods could be further lathed, center-less grinded or even fine polished. 
General tolerance of titanium rod is h9-h11. RETIMET are able to guarantee an h/H7 tolerance 
Available grades 
CP grade (Gr1-Gr4) 
Ti-6Al-4V and ELI (Gr5 and Gr23) 
Ti-Pd (Gr7, Gr11, Gr16, Gr17) 
Ti-3Al-2.5V (Gr9) 
Ti-0.3Mo-0.8Ni (Gr12) 
Ti-6Al-7Nb (TC20) 
Ti-13Nb-13Zr (TC21) 
Ti-15V-3Al-3Cr-3Sn (Ti-15333, TB5) 
Ti-6.5Al-1Mo-1V-2Zr (TA15, BT20) 
Ti-6Al-2Sn-4Zr-2Mo 
Ti-6Al-2Sn-4Zr-6Mo 
Ti-3Al-8V-6Cr-4Mo-4Zr 
Ti-Zr alloy 
Ti-Nb alloy (55: 45, 70: 30, 80: 20 wt%) 
Ti-Ni alloy (Nitinol)

GR1	8-75	280	170	24	30
GR2	8-75	370	250	20	30
GR3	8-75	440	320	18	30
GR4	8-75	540	410	15	25
GR5	8-50	895	825	10	25
	>50-70	895	825	10	20