Industrial cyclone dust separator

Industrial cyclone dust separators are often employed as an Initial Stage Collector to lighten heavy dusts loads before being sent to a Primary Stage Fabric Collector. By removing coarse particles from the gas stream, and allowing later stage Fabric Collectors to solely remove finer particles, these collectors increase the efficiency and service life of Fabric Collectors (Baghouses) and their Filters. Thus protecting your larger and most costly investment from unnecessary wear and tear.
It often named after the cyclone weather phenomenon, are large funnel shaped sheet metal tubes connected to ducts often used in woodshops, machine shops, manufacturing plants, and powder processing plants.  Dust and debris are sucked in at the top.  Air containing fine dust blows out of the other side of the top, while chips and large dust particles fall out of the bottom into a drum or bin.  Dusty exhaust air is either blown outside or filtered again using media filtration.


Industrial cyclone dust separator working principle

As the dirty air enters the cyclone dust collector, it is forced into a swirling movement. This results in a centrifugal force acting on the dust particles suspended in the air stream. The particles, denser than the air, are forced to move outwards, towards the cyclone dust collector wall. They then fall downwards, towards the dust exit. The clean air is eventually directed towards the centre of the cyclone and leaves through the gas exit.

Industrial cyclone dust separator efficiency is a function of the physical parameters of the particles and the design parameters of the unit. Cyclone efficiency increases with:
1. Coarse particle size distribution
2. Higher products specific gravity
3. Lower gas density
4. Smaller outlet diameter. An increase in pressure drop also results.

Industrial cyclone dust separator Characteristic
The Cyclone dust collector hasn't any moving parts. It's conenient for manufacture and management. With the same air volume, The cyclone collector is more smaller size, and the price is more cheaper. As the second dedusting and matched with bag filter, it can be installed vertically, also can be installed in a horizontal. So, it is easy to install and applicate. The cyclone collector efficiency of resistance is not affected for many sets of cylcone dollector in multiple using when processing the large dust gas air volume.


Industrial cyclone dust separator Technical parameter for reference

Wind speed at inlet	Wind amount (m3/h)			Pressure drop
m/ses	F3363	2*F3363	4*F3363	Water column
14	5040	10080	20160	~80
16	5760	11520	23040	~105
18	6480	12960	25920	~137
20	7200	14400	28800	~167

Industrial cyclone dust separator service
1.Reply you in the 24h
2.Reply you in English
3.Design according to technical requirement
4.Special discount and protection of sales are provided to distributor
5.We could do the field test to show the machine operation and work effect
6.We are manufacture, we could promise the quality and price


Qingdao Rovan Machinery Co., Ltd
1.Established in 2001the factory is located in Qingdao, China.
2.Mainly manufacture shot blasting machine, dust collector, microseism squeeze molding machine/sand molding machine, core shooter machine, resin sand production line, clay sand production line, etc.
3. All products has ISO9001 and CE certification,
4. OEM also could provide for you.