1 Frame structure
The frame has designed by UG software, welding solid steel structure is the resulting fabrication are extremely giving minimal deflection under load. Welded parts will enter heavy duty electric annealing furnace for stress releasing, to assure stability and reliability.

Main component is designed and Finite Element Analyzed through ANSYS/UG software. 

Main frame composes of uprights, working table, holding-down beam and oil tank.

2 Blades

Exchangeable Rectangle blade, with 4 cutting edges available on each blade.  
Blade material 6CrW2Si with hardness HRC58-60, with quality shearing result and long life. 
The blade is suitable for cutting both mild steel and stainless steel.

3 Shearing length/stroke adjustment
 
The shearing stroke could be adjusted through knob according to the length of the product. Thus efficiency and productivity could be improved when cutting shorter length product. 
Blade gap adjustable

4 Cutting beam guiding and blade clearance

The cutting beam is guided between roller guides. At the rear of the cutting beam there are two sets of upper and lower roller guides located at each end of the beam. 
Two spring-loaded rollers located at the front of the shear apply pressure to the cutting beam, forcing it against the back roller guides. 
The bearings of the upper roller guides at the back of the cutting beam are mounted on an eccentric shaft. Rotating this shaft causes the cutting beam to tilt, thus providing proper blade clearance to the shearing blades. 
The upper cutting beam inclined forward, with high section-cutting quality on the product.
The blades clearance could be adjusted according to material and thickness.
 
5 Hydraulic system

Compact hydraulic system for is adopted. Integrated mono-block valve group and worldwide famous valves and seals are adopted for reliability, and the pipeline and connections are reduced to the minimum level to ensure minimum maintenance.
With in-series cylinders to achieve good synchronization movement of the top blade beam. 
The sheet is pressed by hold-down cylinders before shearing for safety and reliability during shearing. Over-load protection for the safety of hydraulic system by adopting relief valve. 

6 Hydraulic valve is from Argo, Germany

Oil seals from NOK, Japan or MERKEL, Germany. With minimum wear and tear, no oil leakage. 
High-pressure internal gear pump from KCL, Taiwan or NACHI, Japan, with reliability, efficiency and low noise. 

7 Working table

Transporter ball and supporting bar mounted on working table.
One squaring arm with scale and disappearing stop, length 1500mm.

8 Safety device

We can install side/back fence,light protection device per customer's requirments.
Fence guard for preventing finger being cut. With safety switch. 
One set of movable remote foot switch with emergency stop switch.