Operation Instruction 1. Installation There are two steel bars with wheels to be assembled respectively to both sides of the base.Use wrench to remove a M10 screw with spring washer from one side of the base.Then align two holes in one bar with the screw heads in the side of the base and screw the previous removed M10 screw. Assemble another bar in the same way.After making sure the instrument table is evenly placed,re-tighten two M10 screws. 2. Input Voltage 110V/220V~ 3. Electrical Outlets There is one or two outlet provided. CAUTION: The maximum current drawn must not exceed 6 amp. 4. Fuse Replacement To replace a fuse ,disconnect the power cord from the input outlet and then remove the cover of the fuse holder,which will expose the fuse .After determining and correcting the cause of the fuse blowing,insert a new fuse and screw the cover back into postion. Reconnect the power cord and then check the operation of the table. Fuse Capacity:5A 5. Accessories Hexagon Wrench 1 Fuse 2 6. Note: Check the setting on the voltage selector located on the side of the base. Ensure the local voltage corresponds to the input voltage.