Output Current	DC                         200mA
	Scr                         200mA
Output voltage drop DC/AC	Less than 3.9V
Consumption current	DC12V : 8mA           DC24V: 15mA
Standard detected object	20*20*1     (A3 iron)
Repeated precision	0.02
Working enviroment temperature	-25C  -   +75C
DC/AC Response frequency	400HZ / 25HZ
Insulation resistance	more than 50  Ω
Shell material	Plastic
Protection grade	IP67

Working principle inductive of proximity switch
  Inductive proximity  switch is composed of three parts:  oscillator, switch circuit  and magnified  output  circuit.
  The oscillator  will  generate an  alternating  electric  field.
  When hemetalobject approaches this electric field and reaches the induction distance, whirlpool will generate in metal object, resulting in attenuation of vibrati on and then stop.
  The changeof vibration and stop of oscillator is treated by behind stage mag- nifide circuit and convertedto switching  sign, triggering driving control for  non-contact detection.

  Features of proximity switch

Mian features:
Take high frequency oscillation type proximity sensor(front detector)as representative example to briefly explain general features of proximity switch

  About detected object:

  When the material of detected object is non magnetic metal, the distance of action should deseend.
   But when the foil material is approximately thicker than a.01mm,the detection distance  will be  the same  as that  of magnetic  objest.
  If the  fiIT plating is  ectremely thin or  non-conductive, detection cannot be conducted.
  The effect of cladding material,When detected object has cladding material, take note of the changing of detection distance.

  About  maintenance and overhaul
    ·In order to keep the proximity sensor to work stably for longtime, the following regular examinations should be performed just like general control

  1. Check the installation pocition of detected object and proximity sensor if any deviation,loosening or deformation exists.
  2.  Check  the  attached wires  and  connecting  parts if  any loosening,bad contact or wire breaking off exists.
  3. Check if there is any metallic powder accumulation or not.
  4. Check if the temperature condition and surrounding environment condition are normal or not.
  5. Check if the detection distance is normal or not.