metal steel roofing roll forming machine Technical Specification

(1) Manual decoiler

Un-powered; single head;

max.capacity: 5000kg;
Coil inner-diameter: 508mm

(2) Roll-Forming M/C:
Steps:13 Roller Material: 45# steel

Voltage:380V/50Hz. line speed:3-6m/min;

Rolling chromium thickness:0.05 mm

(3)Pressing Die:

It adopts hydraulic drive and automatic location to decide the dimention and press the target products.

Stop to press, Post to press

Press tool material: 40Cr and heat-treated

(4) Cutting Mechanism

It adopts hydraulic drive and automatic location to decide the dimention and cut the target products.

Match equipment : one set of cutting tool, one hydraulic tank ,one cutter machine.

Stop to cut , Post cut cutting length tolerance: ±2mm

Cutting tool material: GCr12 with quenched treatment 60-62°C

(5) Hydraulic System

It is controlled by gearwheel oil pump. After filling the hydraulic oil into the hydraulic oil tank ,the pump drive the cutter machine to begin the cutting job.

Match equipment: a set of hydraulic tank , a set of hydraulic oil pump, two hydraulic pipes and two sets of electromagnetism valves.

Power of the oil pump: 3kw Hydraulic oil :40#

(6)Computer control cabinet :

It adopts Taida PLC to control. The target piece length is adjustable and digit of it can be adjusted

Computed mode has two modes: automatic and manual one.

(7)Counter :

One counter gauges length, pulses, and decides length

 (8) Output table

It used to load the forming plate

If any questions,you can call me mobile phone at any times

3:If you want to get more pictures or videos of the machines,I can send them to you by Email or SKype