1:Breif introduction:

This is a sort of Wireless DMX Controller (Signal Emission) to receive the DMX signal from DMX console and emit the signal to another Wireless DMX Controller (Signal Receipt) to control the fixture in DMX signal.

2:Specification:

Model Name:2.4 GWireless DMX Controller

Input Power:9V/500MA

Transmission Distance:400M (Blank place)

Working Frequency:2400M~2431M(2.4G ISM)

Transmission Power:20DBM

 3:Sketch:

(1.) Antenna SMA Connector

 (2.) DC input outlet

 (3.) DMX signal indicator light

 (4.) Wireless Remote indicator light: Signal Receipt (RED),Signal Emission (Green)

 (5.) The Dip Switch 1, code No.1-No.4 for setting up the connection address for Signal Receipt controller when more than 2pcs are connected (real time setting available)

(6.) The Dip Switch 2, code No.1-No.5 are for setting up of choosing the working frequency, No.6 is the On-Off switch of the signal receipt and signal emission (ON is for signal emission, OFF is for signal receipt, reset need to cut off power first) (real time setting available)

4: Operation instruction:

(1.) When you take it to be the SIGNAL EMISSION controller, the DMX signal Indicator light (4) is GREEN. SIGNAL EMISSION controller will receive the signal from DMX console and emit it out. If the indicator light (4) flashes, it is working for the emission.

(2.)When you take it to be SINGAL RECEIPT controller, the DMX signal indicator light (4) is RED. SINGAL RECEIPT controller will receive the signal from SIGNAL EMISSION controller and convert it to be DMX signal to control the fixture. If the indicator light (4) flashes, it is working for the receipt. If the indicator flashes irregularly or without any flash, you need to adjust the antenna angel or shorten the space between each other. When you are setting online, the RED light will flash once, if signal keeps on, it will flash; if no signal, it will be off. The shorter distance, the quicker the light flashes.

(3.)When Wireless DMX Controller to be set SIGNAL EMISSION controller,the DMX signal indicator (3) flashes when it receives signal properly form DMX consoles.

(4.) When more than 2pcs Signal Receipt controllers are connected, you need to set up the connection address on the Dip Switch 1 code No.1-No.4.

(5.) Signal receipt or signal emission mode must be set up.

(6.) The Wireless DMX Controller can work at the following frequency:

5. Working environments and cautions:

(1.) The signal emission controller and signal receipt controller must work on the same frequency and same address or it will fail.

(2.) When the signal emission controller and signal receipt controller are working, the antenna must be vertical to the controller so as to set up electromagnetic field to make sure better signal transfer.