Gr5 titanium alloy

Low GR5 titanium alloy heat treatment:

Mpa, after solid solution strengthening treatment GR5 material, strength increase is not big, also to 1100 mpa, the strength is in commonly 900 mpa back fire condition

Low thermal expansion coefficient of GR5:

GR5 titanium alloy has excellent corrosion resistance, small density, high specific strength and good toughness and weldability and a series of advantages, in the aerospace, petrochemical industry, shipbuilding, automobile, medical departments have been successful applications.

Low GR5 titanium alloy mechanical properties:

Sigma b / 895 MPa or greater tensile strength, of specified residual elongation stress in the sigma r0.2 / MPa or greater 825, 5 (%) of 10 or higher elongation delta, reduction of area bits (%) of 25 or higher

Low density of GR5 titanium alloy:

(4.5 g/cm3) working temperature - 100 ~ 550 ℃)

Low GR5titanium alloy chemical composition:

Allowance for GR5 titanium (Ti), iron (Fe) 0.30, or less carbon (C) 0.10, or less nitrogen (N) 0.05 or less, hydrogen (H), 0.015 or less oxygen (O) of 0.20 or less, aluminum (Al) 5.5 ~ 6.8, vanadium (V) 3.5 ~ 4.5 [1] [2] [3] [4]

Categories: hair stick/polished rod rolling bar/car light stick/bar/cold/hot forging pull rods/extrusion rods/rotary swaging rod

Execution standard: ASTM B 348, ASTM B 367, ASTM B 381, ASTM F 67, ASTM F 136, GB/T 2965, GB/T 13810

Basic grades: TA1 / Gr1, TA2 / Gr2, TA3 / Gr3, TA4 / Gr4, TA5, TA6, TA7 / Gr6, TA9 / Gr7, TA10 / Gr12, TA13, TA15 and TA19, TB2, TC1 and TC2, TC3, TC4 / Gr5, TC4ELI/Gr23, TC6, TC9, TC10, TC11, TC12

Supply: hot working state, cold working state, annealing, hot rotary forging state

Diameter or thickness of section: > 7-230, 5.0-5.0 (hot rotary forging bar)

Length (mm) : 300-300 (hot working state and cold state), 300-3000 (annealing state), 300-1500 (hot rotary forging state)

Can supply other specifications agreed by negotiation between the seller and the buyer bar.