IEC60068 Impact Hammer Calibrator IK Calibration Test Device

Principle of calibration:

The principle of this calibration procedure is to compare the energy provided by a spring hammer, which is difficult to measure directly, to the energy of a pendulum, calculated from its mass and height of fall. And it's designed with the requirements of Annex B of IEC60068-2-75.

 
Construction:

It's maily made of a frame, a bearing, a drag pointer, a pendulum, a release base and a release device.

 

Notes:

The impact Hammer Calibrator can be used for all models, allowing verification of the proper functioning of different types of hammers with the same calibration.

 

The spring is designed for calibrating spring hammers having characteristics as defined for energy values equal to less than 2J.

 

Conforms to:

IEC60335, IEC60065, IEC60745, IEC61029, IEC60601, IEC60610 etc.

 
Technical parameters:

Main parameters	CX-TF06A	Similar products
The actual accuracy	0.01J	0.02J
Repeat accuracy	±0.01J	0.02-0.04J.
Maximum range	0-2J	0.1-2J
Guide groove diameter	51mm	51mm
Pendulum energy loss	<0.002j	<0.008J
Trigger Route	>30mm	<18mm
Weight	1pcs	2pcs