DC5V 9mm LED pixel White waterproof signage letters nameboard led backlight advertising signage IP68

 

 

Specifications:

Product Name	9mm led pixel White signage
Product Size	9m diameter
Hole size	9mm diameter.
Voltage	DC 5V
Power	0.12W
Working Currency	20mA
Bean Angle	180°
Material	PVC
IP Rate	IP68
Working temperature	-45℃～+70℃
Warranty	Three Years
Package	50pcs/string, 1000pcs/pcakge, 6000pcs/cuton
Emitting Color	Red, Yellow,Blue,Green,White,Voilet, RGB,Fullcolor.
Application	This led pixel light is widely used for all kinds of advertising letters,Name board, Wire bar,wall,building and stage decoration.

Feature:

 

1.Produce with Taiwan chip. high lumen, good color purity, lower light dissipation and long lifespan.

 

2.Compared with traditional lights, LED light has the advantage of energy saving, environment friendly, long lifespan, Stable well, install conveniently, ect.

 

3.Monocolour achieve the effect of advertising signs keeping lighting state, fullcolor string suitable for advertising sign whose color is changed always, It makes outdoor advertising signs board produced easily and beautiful appearance.

 

4.Suitable for different material board like Aluminum substrate , stainless steel plate,ect. install conveniently.

 

5.Every piece is connected with series method, If one is down, Just need to exchang the break one. Much different from the kind that need to exchanged the whole roll sting if there is only 1 pcs gone down.

 

6.flexiable enough for installation, high strength, High and low temperature resistance,anti ultraviolet, aging-resistant, Waterproof IP68. 

 

 

 

Driver select and installation:

 

1.Total load power of the driver should not be over than 80% of the driver rated power.

For example: Driver output:DC5V,40A, Rated power is 200W. the load power should not be over

Than 200*80%=160W. If every pcs light is 0.1W, Then the quantity should not be over than

160/0.1=1600pcs.

 

 2.If there is more than one driver, Pls make sure that there is no reture circuit.Otherwise the drivers

Will be burn out.

 

3.Connect ways: When connect the string with driver, pls keep the beging and the end contacted with the main wire . and main wire must be 2.5 mm2 .

If you have more questions, Pls contact with me:

 

Website: