Model: Hot Oil/High Temperature Oil Pump
Application: Hot oil/High temperature oil pump is based on the original Y-type oil pump technology with the introduction of a comprehensive improvement, preservation inheritance, the AY-type oil pump to follow the principle of Y-type oil pump performance drink mounting dimensions.
Product overview
Hot oil/High temperature oil pump  is based on the original Y-type oil pump technology with the introduction of a comprehensive improvement, preservation inheritance, the Hot oil/High temperature oil pumpl  to follow the principle of Y-type oil pump performance drink mounting dimensions.
Hot oil/High temperature oil pump higher than the Y-type oil pump reliability and its efficiency is higher than Y-type oil pump, fully adapted to the petrochemical industry to save energy-centric equipment replacement.
Hot oil/High temperature oil pump  for conveying solid particles of petroleum and its products. Depending on conditions, the main components of a given material is pumped into three categories
Hot oil/High temperature oil pump pump performance parameters (design point)
Flow rate: Q = 6.25-500m3 / h
Head: H = 60-300m
Hot oil/High temperature oil pump is divided into single-stage, two-stage cantilevered and between bearing. See structure General Plan
Housing part: pump, pump cover, etc., all of which bear the working pressure of the pump, inlet direction are vertical. Pump cover cast seal chamber (filling cavities), outside seal cavity alternative cooling chamber jacket with a water-cooled jacket must be especially requested or when the transmission medium is water temperature exceeds 66°C and carbon When exceed 150°Ctemperature with hydrogen compound.
Rotor: impeller, shaft sleeve, impeller nuts, etc., whose single-stage axial pump impeller balance advocated rely Kong Pingheng, two-stage axial pump impeller equipped with its own advocate to rely on balance.
Bearing parts: the main body by the bearings and rolling bearings and other components. Supporting the pump rotor portion also bear the remaining axial force of the pump, the rolling bearing with oil lubrication. Bearing body height optional air cooling (T120°C) according to the medium temperature. Fan-cooled (T = 120 ~ 260°C) and water cooling (T260 ~ 450°C).
Transmission parts: pump and motor using the flexible diaphragm lengthened coupling member connected to the first intermediate spacer coupling overhaul remove, do not move the motor and pump parts were replaced or repair.
Sealing components: According to the conditions of use, can be installed seal chamber packing or mechanical seal.
Steering pump: see pumps from the coupling end counterclockwise rotation.