Provide instruction and operation manual, foundation drawing, layout drawing, vulnerable part drawings, hydraulic system schematic drawing, electric circuit drawing before or when machine is delivered.

 

Provide instruction and operation manual, foundation drawing, layout drawing, vulnerable part drawings, hydraulic system schematic drawing, electric circuit drawing before or when machine is delivered.

Basic technical parameters of coils

a) Material of coils: galvanized plate etc.

b) Strip thickness: 0.4～1.5mm

c) Strip width: 500～1300mm

d)  Inner diameter of coils: Φ500mm

e) Outer diameter of coils: Φ2000mm.

f)  Max. coil weight:15000Kg
 Coil-loading car—single manderal uncoiling-Coil-end-feeding&shoveling-double roller pinching feeding-three-roller-leveling-End-cutting----Strip-aligning----Disk shearing-Scrap reeling-Hole

Accumulator-Pre-separator--Tensioning---Recoiling-coil down car--Hydraulic control-Electric control

Inspection Standards

conditions	Number	Conditions	Number
Width tolerance	±0.03mm	OD of coils	Φ800～2000mm
Camber tolerance	±0.10mm/m	ID of coils	Φ508mm
Hump of recoils	0.5mm	Max. coil weight	Max. 15000kg
Slitting weight of each figuring	Min. 1200T	Min. strip width	21mm
Scrap width of each side	3～8mm	Burs	Less than 5% of strip thickness
Max slitting number	20	Surface quality	Without flaws like edge fold, angle fold, scratch, oil dirt, roller print, crease.