The characteristics of steel bar mesh sheet welding machine

Weft feeding method: Firstly, the coil wires are straighten and cut into fixed length by straightening cutting machine, which become weft wire. Then worker put the weft wires into wire hopper. Wire hopper under the control of air pump, the weft wires falling automatically one by one. 

Warp feeding method: warp wires are the same to weft wires, firstly use straightening cutting machine to straighten and cut coil wire into fixed length. Then the line wires are sent by labor and fed automatically, when it welding and drawing, labors can prepare the wires, it increases the production efficiency.

Welding system: the machine welding system is controled by pneumatic system, which makes the adjusting of welding pressure simple and convenient. At the same time, the welding electrodes are equipped with water cooling system to make sure the welding during a long working time, and prolong the life .

Mesh pulling system:the machine use servo motor to pull the mesh, in this case the mesh size is adjustable and accurate.

Mesh falling system: Automatic falling mesh panel system is adopted, so it save much labor to move the mesh panels. 

Control system:Control cabinet adopt touch screen operate system, you can change welding time or electricity, mesh opening size by print numbers through touch screen.

application of steel bar mesh sheet welding machine:

It can be used for producing high-level construction and bridge mesh, high-way reinforce mesh, construction reinforce mesh, floor pouring mesh, airport reinforce mesh and so on.

uitable materials:

Stainless steel wire, low-carbon steel wire, galvanized wire, iron wire, rebar

accessories of steel bar mesh sheet welding machine:

1.Automatic wire straightening and cutting machine two set

2.One set air compressor, one piece of air tank and air dry machine

3.Wire tray