DTS 202-W-GS-xx

Many thanks for purchasing media converter with 2*1000base fiber ports and 2 RJ45 ports (10/100/1000M adaptive)! This product supports IEEE802.3U IEEE802.3z 1000Base-Tx/Fx protocol, as well as full duplex and half duplex mode. The following purchasing guide is for customer's reference.

Brief introduction
Many thanks for purchasing media converter with 2* 1000base fiber ports and 2 RJ45 ports (10/100/1000M adaptive)! This product supports IEEE802.3U IEEE802.3z 1000Base-Tx/Fx protocol, as well as full duplex and half duplex mode. The following purchasing guide is for customer's reference.

Main features
1. In conformity to IEEE 802.3 10 Base-T standard. In conformity to IEEE 802.3u 100 Base-TX, IEEE802.3z, IEEE802.3abstandard.
2. Built in high efficiency SRAM for packet buffer, with 1K-entry lookup table and 4-way associative hash algorithm.
3. Half duplex: back pressure flow control
Full duplex: IEEE802.3x flow control
4. Automatic identification of MDI/MDI-X cross line.
5. In conformity to safety code of FCC and 15 CLASS A and CE MARK.

Technical parameters
1. Standard Protocol: IEEE802.3 10 Base-T standard
IEEE 802.3u 100Base-TX and IEEE802.3z standard
2. Connector: 2 UTPRJ-45 connector, 2 SC/ST connector
3. Operation mode: full duplex mode or half duplex mode
4. Power supply parameter:
Adapter(External): 110-265V AC input, 5V1A DC output
Power(Internal): 110-265V AC input, 5V1A DC output
5. Environmental temperature: -10℃ - 50 ℃
6. Relative humidity: 5%-90%
8. TP cable: Cat5 UTP cable
9. Transfer fiber:
multi-mode: 50/125, 62.5/125 or 100/140μm
single mode: 8.3/125, 8.7/125, 9/125 or 10/125μm
10 Dimensions:
Power outside: 130mm(L) x 119mm(W)x 30mm(H)

Cautions
1. This product is suitable for indoor application.
2. Put on the dust cover of fiber interface when not used.
3. It is forbidden to stare at the TX fiber-transfer end with naked eyes.
4. Single optical fiber transceiver must be used in pair (See the attachment description in delivery).

Trouble shooting
1. Device is not matched. Please select the corresponding network device according to the transfer rate of the product (10Mbps or 100Mbps, 1000Mbps) when connected to other network devices (network card, hub, switch).
2. Line loss is excessive during the fiber wiring. Excessive loss in connector plug-in and fiber soldering welding, and excessive intermediate nodes may cause excessive loss rate or abnormal operation.

VLAN Function
1. Support VLAN , QoS, IPv4, IPv6
2. Support long data up to 10K byte
3. Low consumption, low temperature and good stability
4. Note: When the switch set at left side is VLAN Status, and
Set at right side is DIS. VLAN Status.
All RJ45 Ports are separated when the device set at VLAN
Status . And the equipment no need use in pair.