Before The Curing 

Appearance	Translucent And Half Flow
Relative Density	0.95~1.05 (g/cm3)
Tack Free Time	≤90 (min)
Completely Cure Time	3~7(d)

After the curing  

 

Hardness	35~45 (Shore A)
Tensile Strength	≥1.0 (MPa)
Break Elongation	≥50(%)
The Temperature Range	-60~200 (℃)
Volume Resistivity	≥1.0×1014 (Ω·CM)
Dielectric Strength	≥18 (kV/·mm)

Sample: 1kg/tin (which may be decided according to user's need)

INSTRUCTIONS

1,Clean surface: cleaning adhesion surface and to remove the rust,dust and greasy dirt, etc.

2,After sizing: Unscrew the hose cap (or cutting), squeezing the glue on cleaned surface, so that can be distributed uniformly.

3,Curing: the part of bonded or sealed were cured naturally in the air. The curing is a process from the surface to the internal, the depth of curing is 2 ~ 4mm within 24 hours (at room temperature and 55% relative humidity), if the location of sizing is too deep, especially when it is not easy to contact the air, then the completely curing time will be extended, if the temperature is low, the curing time will be extended either, the fully curing time need at least 7 days if the thickness of sealant is 6mm.