1. Introduction of mango slicer

This machine is mainly to slice mango(without pit). Mahcine is made of full 304 stainless steel. Before this machine, we can offer green mango peeling machine and mango splitting machine. And to use this machine to slice mango, you need remove the pit from splitted mango by hand firstly. 

2. Technical parameter of mango slicer

3. Features of mango slicer  

1: mango slice machine is the product of export power adopts three-phase 220 v power supply frequency is 60 hz, in order to use the safety in the machine, please have a ground even ground wires.
2: mango slice cutting machine cutting direction is counterclockwise. Please hand below the rotary table before starting the turntable to rotate clockwise. Listen to feed tube and blade no friction sound then we will start the machine. Such as "invert change each other will three-phase power supply any two, please. Be sure to keep in mind.
3: the machine can automatically drop when cutting feed raw material and no hand pressure. When the raw material is greater than the feed tube. Please don't shoehorned into. Such as jam, available raw materials instead of hand pressed it down. Can't, iron, bamboo and other types of sand into the feeding tube. More can't use hand into the feeding tube. Cutting is finished, the knife at the end of the check to see whether the mango broken pin plug. If already please clear off. No cutting. Please send incoming cover seal. In order to avoid the sand into the. Damage the blade.
4: thickness adjustment. The machine adopts feeding cover with the host separate. If you need to adjust. The feeding cover under the four corners of nut loose. Take off cover.
Example: adjust the mango slices thickening
'll take out the sword with a gasket. Loosen the screws on the knife down. Look at the sword of the gasket. The sword of the arc and outer arc gaskets gasket minutes. Thicken when the machine is equipped with the gasket to the knife below. Thickness is set by the customer. Remember when upset in the four corners of the screw with the same thickness of small gasket. After completion of testing. Operation method is the same as in step 2. The thin instead.
5: maintenance: cutter in cutting after a period of time should be a spin-off to sharpen. Add oil to protect the blade.Installed the knife edge and the distance of the plastic sheet should be paid attention to. In about 1-1.5 mm.
6: machine. After completing a job from feed tube charge in cleaning with water..