Flotation machine is the key equipment in flotation separation process, which is mainly composed of pulp chute, mixing device, air charging system, mineralized froth discharging device and electro motor. It is suitable for separating non-ferrous and ferrous metals as well as non metals such as fluorite and talc. Flotation machine uses unmanned automatic control system, thus simplifying operation. Additional, mineralization machine adopts special structure, so that the air is sheared more finely, and mixed with the pulp and medicament more uniformly and reasonably. At the same time, the mineralization system, distribution system and flotation tank are made of special wear-resistant materials which are abrasion-resistant, light and strong, thus prolonging the service life of the equipment. Especially, mineralization system is not easy to jam, so it maximize the plant extraction on the premise of meeting fine coal ash requirement.
Working Principle of Gold Processing Flotation Cells/Flotation Machine Manufacturers In China:

The ore slurry and medicament go to the bottom cell of the first room after their full mix. The impeller revolves forming negative pressure in the cavity, making the slurry in the bottom and inside of the cell going to the mixed zone from the up and down absorbing entrance of the impeller, and the air going to the mixed zone through guide sleeve. The air, slurry and medicament have a complete mix. Under the centrifugal force of the impeller, mixed ore slurry flow to the mineralization zone, and damaged air –formed bubble contact with the granules form the mined bubble. Under the influence of stator and Turbulence board, these bubbles, uniformly covering the cell section, move upward to the separate zone, gather to become layer and finally discharge from shaving facility, the fine powder bubble produced. Those non-mineralized granules mix, mineralize and separate again through the cycle hole and the up entrance. Partial slurry which is not absorbed by the impeller goes to the second bottom cell through the middle ore box. After finishing the second then entering the third, the Gold Processing Flotation Cells/Flotation Machine Manufacturers In China work again and again,and through the last ore box the tailings produced.