Archon New WY08 led Diving Flashlight Torch CE Waterproof 4000lumens

 

◆ Model no.: DY02 Diving Light

◆ Bulb: 4*CREE XP-L LED (Max 4000 lumens)

◆ Runtime: high 90 min, low 300 min, strobe 150 min

◆ Output levels: high, low, and strobe

◆ Reflector: glossy aluminum reflector

◆ 4 mm polycarbonate lens

◆ Body material: durable aircraft-grade aluminum

◆ Angle of light beam: 5.5° hot spot

◆ Surface treatment: premium type III hard-anodizing

◆ Color: Black

◆ Battery: 26650 Li-ion battery*2

◆ With battery over-discharging protection, polarity reversing protection

◆ Operation voltage: 8.4 V to 6.0 V

◆ Waterproof: 100 Meters underwater

◆ Dimensions: 244 mm (length) * 59 mm (dia. of lamp head) * 32.8 mm (dia. of lamp body)

◆ Weight in air: ca. 361 g. (without battery); ca.539 g. (with battery)

◆ Underwater weight: ca. 230 g. (with battery)

LOW BATTERYWARNING:

The light flashes 3 times if the power capacity is less than 10%; it repeats after 5 seconds, and then switches to lower brightness. The light switches off when the capacity is less than 5%.

BATTERY INSTALLATION:

1.    Unscrew the lamp tail, holding it pointing upward.

2.    Remove used battery and replace with fresh one per polarity signs.

3.    Screw lamp tail down. Do not over-tighten to break the O-ring.

BATTERY CHARGING:

1.    Plug the charger in the power socket, the indicator light is green in the free-load status.

2.    Put the battery in the slot of the charger.

3.    The indicator light is red if the battery is not fully charged; and it turns green after the battery

     is fully charged.

4.    Unplug the charger, take the battery out, and install it into the light for usage.

MODES CHANGING:

1.    When the light is off, twist the magnetic ring switch to the left to turn it on in high brightness

    mode; then twist the ring to the right to OFF sign and back to the left within 1 second to

    change to low brightness mode.

2.    When the light is off, twist the magnetic ring switch to the right to turn it on in strobe mode.

        CAUTION:

1.    Never attempt to repair or modify the light yourself.

2.    Please check the light regularly for sharp edges, scratches or damages to the 

     surface or O-ring, as this can cause the light to flood under pressure. PLEASE

     LUBRICATE THE THREADS, O-RING GROOVE  WITH SILICONE GREASE TIMELY.

3.    Please rinse the product surface thoroughly after each use. Allow sufficient time to dry

    both inside and outside before storage.

4.    Please remove the battery for transport or storage. Do not lay the battery in a fire or

    expose it to direct heat. Do not wet or hit the battery. Please charge the battery after each

    use, or once every three months, to avoid over-discharging.

5.    Never leave the light unattended when it is on.

6.    Please keep the device out of the reach of children and pets.

7.    Never shine the light to human or pet's eye.

8.    To prevent lens burning caused by over-heating, please do not cover or block the lamp

    head when the light is switched on in the air.

WARRANTY RETURN POLICY:

Please contact your local distributor or retailer for information on how to handle your warranty items.