Amount of 

carbon fiber 

used

Weaving widths up to 600mm can be a one-time heating pad, the product even 

    heating, the appearance of smooth appearance.

Carbon fiber 

heating pad

 electrode tape

Woven belt with electrodes so that good contact with the carbon fiber shaft to

    increase the service life of heating pad

Press-fit 

technoloty

 Special copper-belt equipments,instead of normal soldering technology,

are used more reliable

Adhesive glue

Special high/low temperature resistant glue is used,special equipments are

    used to glue

Conformance with automobile industry QC/T413 standard

Sleeves of 

conductors

Harness with self-produced PVC pipe, wire and using German standard

    and reliable marking on environmental protection

Thin film pressure

sensor of human

body

Function:the circuit is completed only if the sensor is under the pressures

   of over 25kg(55 Ib),no matter the swith is on or off,to avoid the pad idle 

   heating when nobody on the seat and safety peril.

 The life time of the pressure senor,over 1 millon times,the working temperature:

   -40℃(-40 F) ~120℃(248 F)

 With autonomous intellectual proerty right

 All products can be installed with such function

Swithes

 5 files using built-in heating circuit switch, the switch has a sensor short / open circuit / 

   over-voltage protection, and delay opening feature.

Double-coated

adhesive tape

The advanced special glue equipment is used.These are 10mm of two edges of the 

    backing uncoated adhesive,so that the backing is easily ripped open and installation

    time is reduced.