Brainwave controller is a kind of REPRAP 3D printer controller which is derived from Sanguinololu. Through low hardware requirement to drive single screw extruder printer such as single extruder 3d printer, 2 Z axis 3d printer or Delta type 3d printer.

 

Advantage:

1.  12V power input.

2.  Standard Micro USB interface.

3.  All interfaces are outside the board, convenient to connect. 90 degree or 180 degree wire connecting terminal both are matching.

4.  Atmel AT90USB1286 control IC, integrated USB to RS232 function.

5.  Stepper driver subdivision can be full, half, 1/16 and 1/32. Max. current is 800MA.

6.  2 Z axis wire connecting terminal.

7.  All motor output current is adjustable.

8.  Heated bed power and logical part power are separate. Max. is 15A,24V.

9.  Extruder integrated stepper motor, heating, temperature measurement function etc.

10. Speed controllable cooling fan

11. Translator environment: Arduino IDE.

12. Firmware: Marlin.

13. Software: printrun, Repetier-Host.

 

Shenzhen Cashmeral Industrial Co.,Ltd is always here to serve you the best as we can!