WIT pneumatic --- SDA32X50 (COMPACT AIR CYLINDER)

1.Brief Introduction:
(1) Thin and light: In possession of the precision of action and service life,the length is only 1/2 -1/3 normal cylinder
(2) Easy to install,with the embeding type of mounting,it needs nothing and save space.
(3) Easy to Maintain,with simple design to assemble,install and repair easily.
(4) Magnet switch,around the body.leave room for the magnet switch in advance to install and adjust the magnet position more easily.
(5) Adjustable stroke,attached with adjustable nut,cylinder can adjust the stroke within its stroke range.

2.Techincal parameters:
(1) Applicable Medium - Air
(2) Action - Double Acting Type
(3) Proof Pressure - 1.35MPa
(4) Highest Pressure - 1.0MPa
(5) Temperature - 10~60℃
(6) Rod End Thread - 
    Female Thread or Male Thread
(7) Cushion - Mounted Cushion

3.Cylinder Installation Instructions:
(1) Before installation,be sure if the cylinder was not damaged during transportation.check if connecting parts were loose,etc.
(2) When installation,the cylinder piston rod shall not with stand eccentric or radial loads,the load must be consistent with the direction of piston rod axis.
(3) When cylinder installation,especially for long stroke cylinder,it must use level instrument for three-point position calibration.
(4) Before the pipe connects into air intake,it should clear pipe's burrs,pipeline without corrosion,after cleaning up and checked,can be installation.
(5) Speed adjustment: firstly adjusting speed control valve (one-way throttle) in the middle,gradually adjusting the output pressure of regulator,when cylinder speed is close to pre-determine speed,it can ascertain working pressure,and then using speed control valve for fine tuning,Finally adjusting the buffer speed.
(6) After cylinder installation,in working pressure range,to operate 2-3 times without load,checking the cylinder before if is working normally.
(7) At high temperature or corrosive conditions,it should use the appropriate temperature or corrosion resistance cylinders.
(8) In the occasions of humidity,dust or water drop,oil,dust,welding slag,the cylinder should be protected with devices.
(9) In low-temperature environment,it should take anti-freeze measure to prevent water freezing of the system.
(10) If the cylinder is not used for a long time,pay attention to the surface oxion,the intake and exhaust ports should be added plug dust protection.