Product Main

Specifications

16E1 to Ethernet Converter

Features:


  • Realize Ethernet data transmission over 1~16E1
  • Support auto delete the fault E1 channels (BER more than 1E-6 or a serious warning LOS/AIS/LOF or the signal loop back); Auto-restore the use of E1 after eliminate the failure.
  •  for 16 E1 channels, the maximum tolerable time delay difference between any two can be up to 220ms. It will have an alarm for exceed the limit when the time delay difference over 220ms, meanwhile, business interrupt jitter tolerance, jitter transfer characteristics in the line with ITU-T G.823.
  • Provide 4 maximum shared Ethernet interface, support VLAN division based on interface, in the line with IEEE 802.1Q standard
  • Provide 1024 pieces MAC address table, 5 minutes aging time
  • Support frame length: minimum: 64 bytes, maximum: 1916 bytes.
  • Provide flux statistics for each Ethernet interface, such as the fault package number and total package number etc.
  • Provide PAUSE flux control function, can be equipped with network management.
  • Support trunk super terminal management or network management based on SNMP. (optional)
Specifications:
   E1 Interface
    
 Line Rate: 2.048Mbps±50ppm
     Line Code: HDB3
     Interface Standard: ITU-T G.703
     E1 Impedance: 75Ω(unbalance) 
     Connections: dual coax BNC 
     Jitter tolerance: finer than G.742 and G.823
 
10/100Base-T Interface
Rate: 10/100M, full/duplex auto-negotiation
Protocol: Support IEEE 802.3,IEEE 802.1Q (VLAN)
MAC Address Entiries: 4096 Entiries
Total Memory Sizes: 64MBits SDRAM
Physical interface: RJ45, support AUTO-MDIX
 
Power supply                        
Working voltage range wide, good        
Anti-disturb and Isolation, work stable     
DC-48V,range DC-36V~DC-72C   
AC220V,range AC165V~AC240V
 
Environment condition                  
Operating temperature:  0C~+50 C        
Storage temperature:   -20 C~+70 C
Relative temperature:95% (uncondensed)