WATER PROOF TEST CHAMBER

GENERAL INTRODUCTION--WATER PROOF TEST CHAMBER

Aim to use this water-proof tester to verify enclosure performance of electrical and electronic products and protection for
Components and parts inside of those products;

Introduced with full intelligent control system as well as frequency-variant technologies to control rotary angle of test specimen
Rack, swing angle of water-spray swing lever as well as water-spray swing frequency;

Use scientific test design that enables this water-proof tester to provide water-drop, water-spray, water-jet as well as other
Weathering environment;

More than 1000 holes are made and distributed in uniform in the top plate that ensures the water drop in ideal distribution for
Water-proof test;

Distance at 200mm between test specimen and test chamber with test chamber made of stainless steel as well as visible glass
Window for real-time test viewing;

Control system is designed with independent-developed touch panel with PLC & stepping motor, flow meter and pressure valve;

the water sprayer is made of stainless steel and distributed on the bottom of tester to implement line spray. Magnetic valve is
Introduced to control water drop loop. Water spray flow as well as water drop flow can be indicated through relevant meters.

TECHNICAL PARAMETERSWATER PROOF TEST CHAMBER

Test Chamber	Water-Proof Test Chamber
Tester Model	LT-LY-IP1/2
Internal Dimension   DWH	100010001000 mm
Test Table Rotary Velocity	1 ~10 RPM
Rotary Table Diameter	400mm
Rotary Table Control	Tile Angle: 15 Height: 200mm
Water Spray Radius	R 400mm
Water Spray Pipe Swing Range	90,120, 270, 300    avaialble to set
Pipe Diameter	16 mm
Water Spray Hole Diameter	0.4 mm
Spray Hole-Hole Distance	50 mm
Single Hole Water Flow	0.07 L/min +5%
Water Spray Pressure	80-150 Kpa
Swing Frequency Control	Stepping Motor Control
Rain Fall Quantity	1.75L/min
Rain Test Temperature	20-30
Rain Fall Quantity Analysis Accuracy	Less Than 10%
Test Mode	Continuous Test Mode within 10 Days
Swing Pipe Swing Rate	15 Cycles/min. IP3, 10 Cycles/Min. IP4
Water Drop Device IP21	Water-Drop Hole 0.5mm, Hole Distance at 2020mm; Water-Drop Height: Approx. 600mm, Water Tank: 500500 mm
Test Cycle Setting	1-999,999min   Controllable
Water-Spray Pressure	80~100Kpa  Controllable