Slag separator, it is a kind of using the Theory of centrifugal to get rid of slurry density is different from the pulp of Impurities of equipment, upper slag machine adopt stainless steel material, Lower injection for polyurethane material, main wall designs for the spiral Cone.

Slag separator can be used in all kinds of pulp purification system, mainly to remove slurry density is greater than the Size of sand, iron and other impurities (heavy slag) clock and density is less Than the size of such as mixed sticky powder, paraffin wax, heat melt glue, Plastic, foam, gas, light impurities such as ink particles (light slag Separator).

Low concentration slag eliminator:

TH series of low-concentration slag Separator is the principle of centrifugal separation of eddy current. the slurry of the pressure can be entered from the inlet of the cutting edge in the Direction of the tangential direction, and the eddy motion of high speed in the Cone is separated. the vortex in the axial direction of the separation tube is LED to the end of the cone, and the heavy impurities in the slurry are thrown into the wall of the wall and discharged from the lower end. the slurry gathers To the center of the separation tube and forms the main slurry flow, which is Sent out from the upper part of the slurry to the next process.

Technical data of slag eliminator

Single pass amount: 400L/min

Concentration: 0.30 ~ 1.0%

Inlet pressure: 0.25 ~ 0.35 Mpa

Rated entry and exit pressure Differential: 0.15mpa

Minimum good pulp pressure: 0.03 Mpa