| Certification: | CCC |
|---|---|
| Phase: | 2 |
| Holding Torque: | 2NM |
| Step Angle(degrees): | 1.8 |
| Brand Name: | ZHONG HUA JIANG |
| Current / Phase: | 4.5A |
| Model Number: | iHSV57-30-18-36 |
| Type: | servo motor |
| Unit Type: | piece |
| Package Size: | 20cm x 10cm x 20cm (7.87in x 3.94in x 7.87in) |
| Package Weight: | 2.0kg (4.41lb.) |
Quick Details
Specifications
180W NEMA 23 0.57N.m Integrated Servo Motor 36VDC 3000rpm JMC iHSV57-36-18-36
- Multi Pulse Input Modes Pulse+Direction
- Opto-isolator Servo Reset Input Port ERC
- Current Loop Bandwidth:(-3dB)2KHz(Typical)
- Speed Loop Bandwidth: 500Hz(Typical)
- Position Loop Bandwidth: 200Hz(Typical)
- Motor Quadrature Encoder Input Interface: Differential Input(26LS32)
- Download parameters via RS232C from PC or Text Display.
- Users can definite subdivisions via external Dial-up switches or software.
- Overcurrent, I2T, Over-voltage, Undervoltage, Overheat, Overspeed, Overerror Protections.
- Green light indicates running, red light indicates protection or offline
Specifications:
| input voltage | 24~50VDC(36V typical value ) | |
| Continuous output current | 6A | |
| Maximum pulse frequency | 250K | |
| Default rate | 9.6Kbps(Required external conversion interface) | |
| protect | Peak value of over current action value 30A + 10% Overload I2t current action value of 300% 5S Overheating action value of 80 Overvoltage action value 65V Action value of under voltage voltage 18V | |
| Use environment | occasion | As far as possible to avoid dust, oil mist and corrosive gases |
| working temperature | 0~+70°C | |
| Storage temperature | -20°C~+80°C | |
| humidity | 40~90%RH | |
| Cooling mode | Natural cooling or forced air cooling | |
Environment:
| Cooling | Natural Cooling or Forced Convection | |
| Environment | Space | Avoid dust, oil frost and corrosive gases |
| Ambient Temperature | 65°C | |
| Humidity | <80%RH | |
| Vibration | 5.9m/s² Max | |
| Storage Temp. | -10°C -80°C | |
| Weight | Approx. 1.8 Kg | |
Microstep Resolution Setting:
The micro steps setting is in the following table,while SW1,SW2,SW3,SW4 are all on,the internal default micro steps inside is activate,it can set by our servo software.
| Model | Length L(mm) | Shaft length (mm) |
| iHSV57-30-10-36-XXX | 110 | 30 |
| iHSV57-36-14-36-XXX | 130 | |
| iHSV57-36-18-36-XXX | 150 | |
| iHSV57-30-10-36-21-XXX | 110 | 21 |
| iHSV57-30-14-36-21-XXX | 130 | |
| iHSV57-30-18-36-21-XXX | 150 |
Note: Ship 30mm length shaft defautly.
