Instructions & Installations

1.Tools Needed

  Electric drill 6mm (or other sizes depending on the screw being used) diamond  cross"+" and flat"-" screw drivers, a pencil,and an eye-guard face shield.

2.Preparation

  The screws and anchors supplied should only be applied to a solid wall, in case it is a hollow wall, please select and buy your own fittings apply.

3.Selection or installation location

 (1)Select a suitable place on a solid wall

 (2)Always make sure there is no pipe or wire in the wall.

 WARNING: DRILLING INTO PIPE OR WIRE IN THE WALL CAN CAUSE SERIOUS DAMAGE TO YOUR BODY OR PROPERTIES

 (3)Drill holes at clearance between tiles, wherever possible.

 (4)If the user decide to drill into surface instead, please do it with a proper aiguille and set the anchor in the back of tile to avoid tile break, it will be the user's owm risk to drill into the tile surface.

4.Installation(for solid wall only)

 (1)Wear eye-guard or face shield.

 (2)Mark the position to be drilled with a pencil.

 (3)Select and lock suitable to the electric drill.

 (4)Drill a hole at the position marked in procedure 2

 (5)Put the anchor to the holes.

 (6)Screw in bracket with a suitable screw driver.

5.Cleaning

  Only clean and dry the surface with mild-cleaner and soft-cloth. Do not use chemical detergent or rough sponge. It is recommended to clean the surface periodically for  surface.

6.Weight:500g

7.Material :Copper /Brass