NEMA23 2Nm 283oz.in Integrated open loop stepping motor 36VDC JMC iHS57-36-20

 

We can also offer:

NEMA23 1NM Integrated open loop stepping motor JMC iHS57-36-10 shaft length 21mm;
NEMA24 3NM Integrated open loop stepping motor JMC iHS60-36-30 shaft length 31mm;

 

IHS57-XX integrated digital stepper motor driver into the digital stepper motor integrated into the stepper motor, the two perfect blend. The integration of digital stepper motor drive DSP write advanced drive control algorithm, can guarantee the stepper motor in the speed range of precision, stable operation, the built-in subdivision algorithm, which can make the motor run smoothly at low speed; high speed torque compensation algorithm, can improve the motor torque at high speed to the maximum; parameter self-tuning algorithm can maximize the performance of the motor; the built-in smoothing algorithm, can greatly enhance the performance of motor deceleration. In short, this integrated digital drive to meet the application of most applications, is a cost-effective motion control products

 

The motor drive, integration, save complex wiring

The small vibration, low fever, slow running;

The high speed torque compensation;

The current vector control, high current efficiency;

The built-in acceleration and deceleration control, improve the smooth start and stop;

The operation of the motor position memory;

The input signal of differential optocoupler, compatible with 5V~24V;

The user can customize the subdivision;

The current subdivision dial set is convenient;

The overcurrent protection, overvoltage protection, undervoltage protection;

The lights that run, said light protection or offline;

 

Technical Specifications:

Input Voltage		24~50VDC(36V Typical)
Output Current		4.5A 20KHz PWM
Pulse Frequency max		200K
Communication rate		57.6Kbps
Protection		l Over current peak value 8A±10% l Over voltage value 80V l The over position error range can be set through the HISU
Environment  Specifications	Environment	Avoid dust, oil fog and corrosive gases
	Operating Temperature	70 MAX
	Storage Temperature	-20~+65
	Humidity	40~90%RH
	Cooling method	Natural cooling or forced air cooling

 

Microstep Setting:

The micro steps setting is in the following table,  while SW1,SW2,SW3.SW4 are all on, the internal default micro steps inside is activate,this ratio can be setting through the HISU.

Dial switch Micro steps	SW1	SW2	SW3	SW4
Default	on	on	on	on
800	off	on	on	on
1600	on	off	on	on
3200	off	off	on	on
6400	on	on	off	on
12800	off	on	off	on
25600	on	off	off	on
51200	off	off	off	on
1000	on	on	on	off
2000	off	on	on	off
4000	on	off	on	off
5000	off	off	on	off
8000	on	on	off	off
10000	off	on	off	off
20000	on	off	off	off
40000	off	off	off	off