DIY CNCUSB 4 Axis TB6560  USB CNC Stepper Motor Controller Board with Remote Handle

 

I. Package Include:

1 x CNC 4 axis USBCNC controller board

1 x Hand controller

1 x USB cable with Magnetic ring

1 x CD include with English user manual and software and register code

 

II. 4 Axis CNCUSB Stepper Motor Controller Board

Our USB6560T4 is our company new product for 4 axis TB6560 cnc controller board

with USB port,and it is suitable for cnc router machine economical type

 

Feature:

• It is 4 axis and connect with computer, power supply, and stepper motor will be a complete cnc electric controller kit
• 4 decay mode and fit for small than 3A 2 phase stepper motor
• it can connect 8-way limit switch(each axis with up and down limit),this is more advantage than mach3
• It can connect with manual control which could be with off-line work too, it is convenience to adjust the coordinate when tool setting
• 4 current setting:0.75/1.5/2.25/3A
• Extend 3-way relay port which can control as spindle stop-start, water-cooling, and mist spray switch
• Automatic current down, it will be 25% of full current when stepper motor stopped to protect the motor and IC chip
• With 12VDC power supply and for customer connect with 12VDC application or with fan
• Support software is USBCNC, not suitable for mach3,NCStudio.

 

Drawing

 

As above drawing, each defined as follows:

1. USBPROT INPUT,is input with USB port, means connect with computer by this port for signal transmission, pls be careful must use the USB2.0 cable with signal shielding and magnet ring,and wires not more than 2m.
2. MANUAL CONTROL PRO

         3. LIMIT INPUT PROT

 

Note: the Z axis bottom limit definition is same as tool setting in this software, means they are reduplicate

1. MIST&FLOOD PORT, cooling mist and cooling liquid control relay, see drawing follow. 4 pins is MIST GND FLOOD GND, and can connect 2pcs extra replay or used as IO export
2. SPINDLE PORT, spindle control reply, see drawing follow 3pins is Normal Open/COM/Normal close.
3. MOD SW