| Certification: | CCC |
|---|---|
| Unit Type: | piece |
| Package Size: | 25cm x 25cm x 20cm (9.84in x 9.84in x 7.87in) |
| Package Weight: | 0.8kg (1.76lb.) |
Quick Details
Specifications
Wiring diagram
Dimensions
Function:
- Working current setting: the output current conductor is adjusted by three DIP switches SW1 SW3, its output current has eight floors throughout. Specific output current settings, please refer to the unit panel.
-Automatic function of average flow: Users can configure the unit Automatic flow medium function through SW4.OFF shows the static current is set to be mean of the dynamic current, in the static current sample is the same as dynamic current. SW4 must be de-energized in general use in order to reduce engine and driver heating, also to improve reliability. The current will be reduced by 50% automatically approximately 0.3 seconds after the pulse train stop (55% of the actual value), calorific value reduced by 65% ??in theory.
- Micro subdivision adjustment: The micro step subdivision controller is set by four SW5 DIP switches SW8, There are 15 micro step subdivision files in all. When users are creating targeting, the driver must be stopped
First. About micro-step subdivision settings, please refer to the unit panel.
- Indicator light: the units have two red and green lights. One of the green light is on, it will be abidingly on after the driver is electrified; The other red light is fault indicating lamp, being overvoltage and overcurrent problems, trouble light will be abidingly on. After the fault is cleared, the red light goes out. When a driver is deactivated, only re-uploading electricity and reuse can clear the fault.
- Signal interface: PUL + and PUL- are the positive side and negative side of control of the signal DIR + and DIR-are The positive side and negative side of direction signal. ENA + y-are the positive side and negative side of enable signal.
-Interface motor: a + and one side of connectting more and less motor step one step. B + B and B-Connectting plus and minus side of Step Motor B Phase. When a, B two phase exchanges, can cause the motor to the reverse direction.
Power port: use of direct current to supply, operating voltage range is suggested to be 24V-50VDC. Power is greater than 100 W.
-Installation instructions: the limit Dimension of the unit is: 117 * 78 * 34mm. Pitch-row installation is 111mm. Whether horizontal or vertical can Work. (Vertical mounting is recommended). When installing, you should make it close to the metal box to facilitate heat dissipation.
Parameter setting:
LC2054DA Precision Controller uses eight DIP switches to set the segmentation, current dynamics and average / full flow, detailed description as follows: Work current setting: SW1, SW2, SW3; Half / full flow mode setting: SW4; Subdivide microstep adjustment: SW5, SW6, SW7, SW8.
Payment
if you have any problems of payment please contact us!
if you need to buy more goods but the price isnotvery cheap please contact us!
Warranty
All products have been checked and packaged in good condition before dispatch.
ALL peoducts have 1yeas warranty.
If you are not satisfied with our product and service.Please contact us first before giving a non positive feedback or dispute.we will try to our best solve the problems
